Mazda Engine And Engine Cooling Engine Gasoline Belts And Associated Pulleys
Car-and-Safety.com | MAZDA>MAZDA Engine And Engine Cooling Engine Gasoline Belts And Associated Pulleys
Mazda Engine And Engine Cooling Engine Gasoline Belts And Associated Pulleys Reports
17 Mar
| MAZDA NAVAJO 1994 | Serpentine Belt Idler Pulley Is defective. when bearings went, it would cause belt to overheat and then snap. would lose |
| MAZDA 626 1993 | Alternator Belt Prematurely Broke and slipped onto the timing belt, causing it to break which resulted in the bending of the valves. |
| MAZDA 626 1998 | While Traveling On The Highway the tensioner belt fell off from inside of the vehicle. the vehicle shut down and the vehicle had |
| MAZDA 929 1989 | Consumers Union Recommended I Contact you. cam drive belt manufactured by the kelly-springfield divsion of goodyear tire and rubber, separated into shreds |
| MAZDA 323 1993 | Vehicle Experiencing Pan Gasket And belt failures. nlm |
| MAZDA MX 6 1994 | Unspecified Belts Replaced Due To noise, noise is still present. |
| MAZDA NAVAJO 1992 | Belt Failed Causing Noise. |
| MAZDA NAVAJO 1994 | Drive Belt Makes Noise. |
| MAZDA PROTEGE 1995 | The Timing Belt Failed, causing the vehicle to stall. |
| MAZDA 626 1993 | Belt Cleaned Due To Squeal. |
| MAZDA 626 1993 | Engine Belt Snapped Due To pulley it attaches to became bent, resulting in engine noise. |
| MAZDA CX 7 2008 | Tl* The Contact Owns A 2008 mazda cx7. while driving black smoke was expelled through the vents of the vehicle. the vehicle was |
| MAZDA CX 7 2007 | Tl*the Contact Owns A 2007 mazda cx-7. while driving 80 mph, the contact noticed that the air bag light illuminated on the |
| MAZDA 626 1997 | Tl* The Contact Owns A 1997 mazda 626. the contact stated that the vehicle was purchased on april 16, 2007. |
| MAZDA TRIBUTE 2004 | At 39720 Miles I Brought my 2004 mazda tribute in for a problem that turned out to be leaks in the transfer case and timing |
| MAZDA MILLENIA 1999 | I Currently Own A 1999 madza millenia, which i purchased pre-owned, in 2002. i have had nothing but problems and extremely |
| MAZDA 626 1998 | My Daughter Was Driving The car in heavy traffic when it stalled and lost all power. it would not start and it was |
| MAZDA 626 1998 | Dt: The Contact had the spring for the timing belt replaced. later, she found nhtsa recall campaign 00v134000 |
| MAZDA 626 1998 | Dt: On September 22, 2005, consumer's vehicle was cut off and it lost power, the vehicle |
| MAZDA 626 1998 | The Car Cut Off While i was driving. the repairman said the problem was due to oil slug build. i had all |
| MAZDA 626 1999 | Vehicle Continuously Stalled When Braking from 40 mph or more and when coming to a stop position. vehicle had been to the |
| MAZDA 626 1999 | While Driving Vehicle Stalled And would not restart. vehicle was towed, and the timing chain was found to be defective.*ak |
| MAZDA 626 1998 | Recall 00v134000 Concerning Timing Belt tensioner: consumer stated vehicle experienced the same problem as stated in the recall . this affected the engine. |
| MAZDA PROTEGE 1999 | My Son Purchased A 1999 mazda protege lx last year. he has had major problems with the engine running hot. he |
| MAZDA 626 1998 | While Driving At 25 Mph check engine indicator light illuminated, and engine stalled. vehicle was towed to independent shop, and mechanic |
| MAZDA 626 1998 | Timing Belt Tensioner Failed Resulting in the vehicle stalling in the middle of the road. manufacturer stated that vehicle was not |
| MAZDA 626 1999 | Recall 00v134000 Concerning Timing belt failure. while driving at 55 mph vehicle stalled. the vehicle had just enough momentum |
| MAZDA 626 1998 | While Traveling 35 Mph Serpentine belt broke and became lodged in the engine, causing engine to stall. *ak |
| MAZDA 626 1998 | I Brought My Mazda 626 lx on 6/1/01 with about 33,000 miles, since then i had to replace my timing belt at 44, |
| MAZDA 626 1998 | While Driving At 35 Mph vehicle stalled timing belt t tensioner malfunctioned, causing the timing belt to break. there's a timing recall |
| MAZDA 626 1998 | While Driving Vehicle Lost power. vehicle was towed to a repair shop. mechanic stated that the timing belt needed |
| MAZDA 626 1998 | While Traveling At 30 Mph tensioner belt fell off inside the engine and broke the timing belt. vehicle stalled, and had |
| MAZDA 626 1999 | Consumer States That Timing Belt failed while driving, causing vehicle to stall. related recall 00v134000, but consumer's vehicle not included |
| MAZDA 626 1998 | The Vehicle Stalled While Driving and would not restart. the vehicle had to be towed to the dealer. a |
| MAZDA 626 1999 | The Timing Belt Tension Spring broke and caused engine damage. the vehicle was taken to an independent mechanic for repair. *nlm |
On This Page
- Select and View Mazda Engine And Engine Cooling Engine Gasoline Belts And Associated Pulleys Problems
- Discuss Mazda Engine And Engine Cooling Engine Gasoline Belts And Associated Pulleys Problems
Today I backed up in a narrow parking lot and as I put my 2009 Mazda 6 in drive and with my foot still on the brake the car accelrated unexpectedly over about 10 feet and into a building, the engine revving and smoking as I put it in neutral and t Another really difficult thing to diagnose was the engine light, and warning bell sounding off for a yr. the dealer ship misdiagnosed the problem. Charged me for a diagnostic test they did not do. They sold me a battery, and sent me down the r my 2006 mazda tribute 24valve v6 engine is a headache when engage to drive it does notmove check battery in trunk it can shift if not incorrect position and arc on posivtive side also make engine light come on showing code pp303 Why does my Mazda 3 stall only when the engine is cold.