Gmc Steering Linkages Reports
22 Mar
GMC VANDURA SERIES 1995 | Safety Pin Was Never In place, tie rod broke and wheel is coming off. tt |
GMC JIMMY 1999 | During Yearly Inspection Mechanic Noticed both front lower ball joints were broken. consumer failed state inspection due to this. *ak |
GMC SAFARI 1996 | Front Tie Rods, Within 1500 miles apart, broke. dealer stated vehicle has a bad setup, and tie rods |
GMC JIMMY 2000 | Consumer Was Going 30mph On a dirt road and suddenly applied brakes to keep from hitting an animal. vehicle spun around, and |
GMC JIMMY 1998 | Premature Failure Of Upper ball joint. dealer has replaced ball joints , also, pitman and idler arm |
GMC SAFARI 1994 | Had Vehicle In For Tire change. mechanic noticed front end had loose idle arm. could lose steering power & control, if not |
GMC JIMMY 2000 | Vehicle Is Pulling To Right at all times, 5 alignments were done, pitman arm and rotor arm was replaced. then, |
GMC JIMMY 1997 | The Dealer Knew About The defects to this vehicle and refused to fix them after receiving 3 separate estimates. 2 days after i repeatedly |
GMC YUKON 2000 | My Yukon Dies At Stop lights &stop signs for no reason . both electric window motors have failed . the back |
GMC JIMMY 1994 | Problem Still Happening After Two years and two mechanics. no summary listed for above vehicle. *ak |
GMC SAFARI 1997 | Gm Chas A Failure In the safari and they don't care, it's a lemon!! no safety defect stated.*ak |
GMC SUBURBAN 1996 | Truck Pulls When Braking. tbs fix implemented with little to no improvement. last time at dealer, dealer said gmc has |
GMC YUKON 2000 | Rear Windows Inoperable 3 Times/right front seat belt locks up, have to unbelt to get slack so passengers reluctant to use belt/transmission has trouble |
GMC JIMMY 1998 | Failed Wheel Bearing And Loose pittman arm - both were replaced |
GMC SIERRA 2000 | Tie Rod Came Unbolted While driving slow speed in line to board a state ferry. lost steering. very lucky we were not |
GMC JIMMY 1997 | Front Upper And Lower Ball joint and idle arm needed replacement. |
GMC SUBURBAN 1995 | No Summary |
GMC SONOMA 1998 | Truck Makes Popping Noise In front end when turning or stopping hard. vehicle has had 6 service orders for this same problem. |
GMC C1500 1998 | Witnessed Carl Black Dealership Cover-up safety problems too myself and many customers in my many hours in thier dealership (they routinely call safety problems as |
GMC SAFARI 1989 | Without Warning The Tie Rod ripped itself out of the frame. if this vehicle had been traveling at normal speed, the driver |
GMC SUBURBAN 1996 | Tie Rods Broke, Causing consumer to lose control of vehicle, resulting in accident. |
GMC C1500 1988 | Pitman And Idler Control Arms failed. |
GMC JIMMY 1992 | Pittman Rod/steering Arm Worn. *sd |
GMC GMC 1994 | Steering Linkage Replaced. *sd |
GMC C3500 1993 | Pitman Arm Replaced. |
GMC SIERRA 1500 2005 | Steering Intermediate Shaft Rattles / has excessive slack in it. have had it repaired under warranty and is now doing it again. dealer |
GMC TOPKICK 2004 | Dt*: The Contact Stated Upon inspection, the vehicle's drag links were worn out to the point of falling off. the contact expressed |
GMC TOPKICK 2004 | Dt*: The Contact Stated Upon inspection, the vehicle's drag links were worn out to the point of falling off. the contact expressed |
GMC C4500 2005 | Unfixable Front End Vibration. vibration is severe 8-12 mhz @ .27g's. over 10 attempts to fix with no results. 4 sets |
GMC SIERRA 2500 2006 | Vehicle- 2006 Gmc Sierra 2500hd 4x4 duramax/allison there is a very noticeable clunk/looseness in the steering. i have greased/lubricated the whole steering |
GMC SIERRA 2500 HD 2004 | Intermediate Shaft Continues To Rattle. was fixed under warranty once. vehicle is now out of warranty and cost $110 to lube the shaft, |
GMC SIERRA 2003 | I Own (2) 2003 Gmc trucks and they both started this "clunking" noise in the steering. i have taken both of them back |
GMC JIMMY 1997 | Transmission Failure / Replaced Transmission - upper & lower ball joint failure / replaced upper & lower ball joints - rear window wiper failure |
GMC YUKON XL 2003 | 2003 Gmc Yukon Xl Has been experiencing multiple problems with front suspension and steering column since it was new. at approx. 4, |
GMC SIERRA 2003 | Steering Assembly Knocks, Clunks, rattles, can feel in the steering wheel and can hear audibly, especially at speeds under 30mph. |
GMC YUKON XL 2002 | Promblems Started At 16,471 steering started rattling,and felt loose,dealer looked at & lubricated intermediate shaft along with downshifting on its own ?? |
GMC SIERRA 2002 | Front Suspension/ Steering 'rattles' Excessively when in a turn and road rough to the point i must accommodate it in how i driven turns. |
GMC TAHOE 2003 | When Driving Around Corners,mild to severe,vehicle started making a clicking noise they stated it was in the steering shaft would order new part |
GMC YUKON XL 2003 | 2003 Gmc Yukon Xl, having a clanking noise when turning right. also, steering wheel vibration as if something is loose in the |
GMC DENALI 2003 | While Getting The Vehicle Checked up for a vacation, the dealer found that the steering linkage was about to fall out. by |
GMC SUBURBAN 1999 | I Have A 1999 Gmc suburban that is having a problem with the power steering. i have taken it 3 times to a repair |
GMC SUBURBAN 1999 | Steering Pulled To The Right. no impact reported. *ak |
On This Page
my system is leaking really bad on my 2001 gmc 2500 was told it is a power steering hydraulic booster can not find one anywhere Every time I move the tilt steering wheel up or down the windshield wipers operate for 2 or 3 swipes. Any ideas? Tom@losbanopsrelestate.com i just replaced the steering sensor and the truck still wanders and has play between 11 an 1 oclock any ideas what it could be sorry it is a 97 gmc yukon that i replaced the steering sensor on i replaced the steering sensor on my 97 gmc yukon it stop sliping but i still have play inbetween 11 and 1 oclock and tends to wander any idea whats wrong?
is this a re call